Drawmer SIX-PACK Specifications download pdf (Page 11)

SIX-PACK” OPERATORS’ MANUAL 9

LED flickers during a piece of quiet but wanted material that it is having a detrimental

effect. When it first comes

into play, the ratio of expansion is very low so trust your

ears!

Finally, set the Gain control to give the required output level using the level meter

to guide you. A

void running at very high output levels as this reduces the available

amount of signal head room and could lead to distortion in extreme cases. Once the

gain is correct, set the Peak Limiter Level control so that the limiter LED only lights

briefly on extreme signal peaks. Alternatively, set the Peak limiter Level to the

desired value and then adjust the compressor Gain control to ensure minimum

limiter activity.

If required, the expander may be used on its own with the compressor and limiter

functions disabled. The Peak limiter has no se

parate on / off control, but turning the

Level control fully clockwise will prevent any unwanted limiter

action. To effectively

bypass the compressor section turn the compressor Threshold up to its maximum

of +20dB (fully counter-clockwise), set the Ratio to its lowest setting of 1.2:1 and

adjust the Gain to approximately 0dB.

1 2 ... 6 7 8 9 10 11 12 13 14

No comments

Drawmer SIX-PACK Specifications Page 11